Enterasys SecureStack C2 C2G170-24

show maclock
SecureStack C2 Configuration Guide 23-51
show maclock
UsethiscommandtodisplaythestatusofMAClockingononeormoreports.
Syntax
show maclock [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,MAClockingstatuswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayMAClockinginformationforge.1.1.
C2(su)->show maclock ge.1.1
MAC locking is globally enabled
Port Port Trap Aging Max Static Max FirstArrival Last Violating
Number Status Status Status Allocated Allocated MAC Address
------- ------- -------- ------- ---------- --------------- ---------------
ge.1.1 enabled disabled enabled 20 1 00:a0:c9:39:5c:b4
Table 23‐6providesanexplanationofthecommandoutput.
set maclock static 23-56
clear maclock static 23-56
set maclock firstarrival 23-57
clear maclock firstarrival 23-58
set maclock agefirstarrival 23-58
clear maclock agefirstarrival 23-59
set maclock move 23-59
set maclock trap 23-60
For information about... Refer to page...
port‐string (Optional)DisplaysMAClockingstatusforspecifiedp ort(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“ PortString
SyntaxUsedintheCLI”onpage 7‐2.