Enterasys SecureStack C2 C2G170-24

SecureStack C2 Configuration Guide 4-1
4
Activating Licensed Features
Inordertoenableadvancedfeatures,suchasadvancedroutingprotocols,youmustpurchaseand
activatealicensekey.Ifyouhavepurchasedalicense,youcanproceedtoactivateyourlicense as
describedinthissection.Ifyouwishtopurchasealicense,contacttheEnterasysNetworksSales
Department.
Purpose
Toactivateandverifylicensedfeatures.
Commands
license advanced
Whenanadvancedlicenseisavailable,usethiscommandtoactivatelicensedfeatures.Ifthisis
availableonyourSecureStackC2switch,auniquelicensekeywilldisplayintheshowlicense
commandoutput.
Syntax
license advanced activation-key
Parameters
Defaults
None.
Mode
Globalconfiguration:router(Config)#
For information about... Refer to page...
license advanced 4-1
show license 4-2
no license advanced 4-2
activation‐key Specifiesyourunique16‐digithexadecimaladvancedlicensingkey.
Note: When available, the licensing key will display at the top of the show running-
config command output. .