Enterasys SecureStack C2 C2G170-24 - Set Ip Protocol; Show Ip Protocol

show ip protocol
3-12 Basic Configuration
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearthesystemIPaddress:
C2(rw)->clear ip address
show ip protocol
Usethiscommandtodisplaythemethodusedtoacqu ireanetworkIPaddressforswitch
management.
Syntax
show ip protocol
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythemethodusedtoacquireanetworkIPaddress:
C2(su)->show ip protocol
System IP address acquisition method: dhcp
set ip protocol
UsethiscommandtospecifytheprotocolusedtoacquireanetworkIPaddressforswitch
management.
Syntax
set ip protocol {bootp | dhcp | none}
Parameters
Defaults
None.
bootp SelectsBOOTPastheprotocoltousetoacquirethesystemIPaddress.
dhcp SelectsDHCPastheprotocoltousetoacquirethesystemIPaddress.
none NoprotocolwillbeusedtoacquirethesystemIPaddress.