Enterasys SecureStack C2 C2G170-24

SecureStack C2 Configuration Guide 14-1
14
Logging and Network Management
Thischapterdescribesswitch‐relatedloggingandnetworkmanagementcommandsandhowto
usethem.
Configuring System Logging
Purpose
Todisplayandconfiguresystemlogging,includingSyslogserversettings,Syslogdefaultsettings,
andtheloggingbuffer.
Commands
Note: The commands in this chapter pertain to network management of the SecureStack C2
device from the switch CLI only. For information on router-related network management tasks,
including reviewing router ARP tables and IP traffic, refer to Chapter 19.
For information about... Refer to page...
Configuring System Logging 14-1
Monitoring Network Events and Status 14-12
Managing Switch Network Addresses and Routes 14-17
Configuring Simple Network Time Protocol (SNTP) 14-27
Configuring Node Aliases 14-35
For information about... Refer to page...
show logging server 14-2
set logging server 14-3
clear logging server 14-4
show logging default 14-4
set logging default 14-5
clear logging default 14-6
show logging application 14-6
set logging application 14-7