Enterasys SecureStack C2 C2G170-24

disconnect
SecureStack C2 Configuration Guide 14-15
C2(su)->show users
Session User Location
-------- ----- --------------------------
* telnet rw 134.141.192.119
telnet rw 134.141.192.18
disconnect
UsethiscommandtocloseanactiveconsoleportorTelnetsessionfromtheswitchCLI.
Syntax
disconnect {ip-addr | console}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Examples
ThisexampleshowshowtocloseaTelnetsessiontohost134.141.192.119:
C2(su)->disconnect 134.141.192.119
Thisexampleshowshowtoclosethecurrentconsolesession:
C2(su)->disconnect console
show netstat
Usethiscommandtodisplaynetworklayerstatistics.
Syntax
show netstat
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
ip‐addr SpecifiestheIPaddressoftheTelnetsessiontobedisconnected.This
addressisdisplayedintheoutputshownin“showusers”onpage 12‐15.
console Closesanactiveconsoleport.