To Next Page

To Previous Page

SecureStack C2 Configuration Guide 7-1

Port Configuration

ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.

Port Configuration Summary

C2H124-48 and C2H124-48P Switch Ports

TheC2H124‐48stackabledevicesprovidethefollowingtypesoffrontpanelconnections:

•Forty‐eightfixedRJ4510/100MbpscopperFastEthernetports

•FourSFPslotsthatprovidetheoptionofinstallingSmallFormPluggable(SFP)Mini‐GBICs

for1000BASE‐Tcompliantcopperconnectionsor1000BA SE‐SX\LX\ELXfiber‐optic

connections

C2G124-24, C2G124-48, and C2G124-48P Switch Ports

TheC2G124‐24,C2G124‐48and C2G124‐48Pstackabledevicesprovidethefollowingtypesof

switchportconnections:

•Twenty‐fourorforty‐eightRJ4510/100/1000Mbps1000BASE‐TFastEthernetcopperports

For information about... Refer to page...

Port Configuration Summary 7-1

Reviewing Port Status 7-3

Disabling / Enabling and Naming Ports 7-6

Setting Speed and Duplex Mode 7-10

Enabling / Disabling Jumbo Frame Support 7-13

Setting Auto-Negotiation and Advertised Ability 7-15

Setting Flow Control 7-19

Setting Port Link Traps and Link Flap Detection 7-21

Configuring Broadcast Suppression 7-30

Port Mirroring 7-33

Link Aggregation Control Protocol (LACP) 7-38

Configuring Protected Ports 7-52

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24