Enterasys SecureStack C2 C2G170-24 - Set Policy Rule

set policy rule
11-10 Policy Classification Configuration
|Ether II packet type | | | X | X | X | X | | | |
|LLC DSAP/SSAP/CTRL | | | | | | | | | |
|VLAN tag | | | | | | | | | |
|Replace tci | | | | | | | | | |
|Port string | X | X | X | X | X | X | | | |
=============================================================
set policy rule
UsethiscommandtoassignincominguntaggedframestoaspecificpolicyprofileandtoVLANor
Class‐of‐Serviceclassificationrules.
Syntax
Thiscommandhastwoformsofsyntax—onetocreateanadminrule,andtheothertocreatea
trafficclassificationruleandattachittoapolicyprofile.
set policy rule admin-profile {vlantag data [mask mask] admin-pid profile-index}
[port-string port-string]
set policy rule profile-index {ether | icmptype | ipproto | ipdestsocket |
ipsourcesocket | iptos | macdest | macsource | tcpdestport | tcpsourceport |
udpdestport | udpsourceport} data [mask mask] {[vlan vlan] [cos cos] | [drop |
forward]}
Parameters
Thefollowingparametersapplytocreatinganadminrule.SeetheUsagesectionbelowformore
informationaboutadminrules.
Thefollowingparametersapplytocreatingatrafficclassificationrule.
Note: Classification rules are automatically enabled when created.
admin‐profile Specifiesthatthisisanadminrule.
vlantagdata ClassifiesbasedonVLANtagspecifiedbydata.Valueofdatacanrange
from1to4094or0xFFF.
maskmask (Optional)Specifiesthenumberofsignificantbitstomatch,dependent
onthedatavalueentered.Valueofmaskcanrangefrom
1to12.
RefertoTable 11‐3forvalidvaluesforeachclassificationtypeanddata
value.
admin‐pid
profile‐index
Associatesthisadminrulewithapolicyprofile,identifiedbyitsindex
number.Policyprofilesareconfiguredwiththesetpolicyprofile
commandasdescribedin“setpolicyprofile
”onpage 11‐3.
Validprofile‐indexvaluesare1‐255.
port‐stringport‐string (Optional)Assignsthisrulewiththespecifiedpolicyprofileonspecific
ingressport(s).Rulewouldnotbeuseduntilpolicyisassignedtothe
specifiedport(s)usingthesetpolicyportcommandasdescribedin“set

policyport”onpage 11‐15.