Enterasys SecureStack C2 C2G170-24

clear radius accounting
SecureStack C2 Configuration Guide 23-9
Mode
Switchcommand,read‐write.
Defaults
None.
Examples
ThisexampleshowshowtoenabletheRADIUSaccountingclientforauthenticatingwiththe
accountingserveratIPaddress10.2.4.12,UDPauthenticationport1800.Aspreviouslynoted,the
“serversecret”passwordenteredheremustmatchthatalreadyconfiguredastheRead‐Write(rw)
passwordontheRADIUSaccountingserver:
C2(su)->set radius accounting server 10.2.4.12 1800
Enter secret:
Re-enter secret:
ThisexampleshowshowtosettheRADIUSaccountingtimeoutto30seconds:
C2(su)->set radius accounting timeout 30
ThisexampleshowshowtosetRADIUSaccountingretriesto10:
C2(su)->set radius accounting retries 10
clear radius accounting
UsethiscommandtoclearRADIUSaccountingconfigurationsettings.
Syntax
clear radius accounting {server ip-address | retries | timeout | counter}
Parameters
Mode
Switchcommand,read‐write.
timeouttimeout Setsthemaximumamountoftime(inseconds)toestablishcontactwitha
specifiedRADIUSaccountingserverbeforetimingout.Validtimeout
valuesare1‐30.
serverip _address
portserver‐secret
Specifiestheaccountingserver’s:
•IPaddress
•UDPauthenticationport(0‐65535)
• server‐secret(Read‐Write
passwordtoaccessthisaccountingserver.
Devicewillpromptforthisentryuponcreatingaserverinstance,as
shownintheexamplebelow.)
serverip‐address Clearstheconfigurationononeormoreaccountingservers.
retries Resetstheretriestothedefaultvalueof3.
timeout Resetsthetimeoutto5seconds.
counter Clearscounters.