To Next Page

To Previous Page

set dhcp pool option

16-28 DHCP Server Configuration

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleremovestheNetBIOSnodetypefromtheaddresspool“auto1.”

C2(rw)->clear dhcp pool auto1 netbios-node-type

set dhcp pool option

UsethiscommandtoconfigureDHCPoptions,describedinRFC2132.

Syntax

set dhcp pool poolname option code {ascii string | hex string-list | ip address-

list}

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Examples

ThisexampleconfiguresDHCPoption19,whichspecifieswhethertheclientshouldconfigureits

IPlayerforpacketforwarding.Inthiscase,IPforwardingisenabledwiththe01value.

C2(rw)->set dhcp pool auto1 option 19 hex 01

ThisexampleconfiguresDHCPoption72,whichassignsoneormoreWebserversforDHCP

clients.Inthiscase,twoWebserveraddressesareconfigured.

C2(rw)->set dhcp pool auto1 option 72 ip 168.24.3.252 168.24.3.253

poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31

charactersinlength.

code SpecifiestheDHCPoptioncode,asdefinedinRFC2132.Valuecanrange

from1to254.

asciistring SpecifiesthedatainASCIIformat.AnASCIIcharacterstringcontaininga

spacemustbe

enclosedinquotations.

hexstring‐list SpecifiesthedatainHEXformat.Upto8HEXstringscanbeentered.

ipaddress‐list SpecifiesthedatainIPaddressformat.Upto8IPaddressescanbeentered.

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24