Enterasys SecureStack C2 C2G170-24 - Set Telnet; Show Telnet

show telnet
3-36 Basic Configuration
show telnet
UsethiscommandtodisplaythestatusofTelnetontheswitch.
Syntax
show telnet
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayTelnetstatus:
C2(su)->show telnet
Telnet inbound is currently: ENABLED
Telnet outbound is currently: ENABLED
set telnet
UsethiscommandtoenableordisableTelnetontheswitch.
Syntax
set telnet {enable | disable} [inbound | outbound | all]
Parameters
Defaults
Ifnotspecified,bothinboundandoutboundTelnetservicewillbeenabled.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableinboundandoutboundTelnetservices:
C2(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
enable|disable EnablesordisablesTelnetservices.
inbound|
outbound|all
(Optional)Specifiesinboundservice(theabilitytoTelnettothisswitch),
outboundservice(theabilitytoTelnettootherdevices),orall(both
inboundandoutbound).