Enterasys SecureStack C2 C2G170-24 - Show Ip Address

show ip address
3-10 Basic Configuration
show ip address
UsethiscommandtodisplaythesystemIPaddressandsubnetmask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaythesystemIPaddressandsubnetmask:
C2(su)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20 255.255.0.0
show banner motd 3-23
set banner motd 3-24
clear banner motd 3-24
show version 3-25
set system name 3-26
set system location 3-26
set system contact 3-27
set width 3-27
set length 3-28
show logout 3-28
set logout 3-29
show console 3-29
set console baud 3-30
For information about... Refer to page...