Enterasys SecureStack C2 C2G170-24

Configuring SNMP MIB Views
SecureStack C2 Configuration Guide 8-19
Example
ThisexampleshowshowtoclearSNMPversion3accessforthe“mis‐group”viathe
authenticationprotocol:
C2(su)->clear snmp access mis-group security-model usm authentication
Configuring SNMP MIB Views
Purpose
ToreviewandconfigureSNMPMIBviews.SNMPviewsmapSNMPobjectstoaccessrights.
Commands
show snmp view
UsethiscommandtodisplaytheMIBconfigurationforSNMPv3view‐basedaccess(VACM).
Syntax
show snmp view [viewname] [subtree oid-or-mibobject] [volatile | nonvolatile |
read-only]
Parameters
Defaults
Ifnoparametersarespecified,allSNMPMIBviewconfigurationinformationwillbedisplayed.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show snmp view 8-19
show snmp context 8-20
set snmp view 8-21
clear snmp view 8-22
viewname (Optional)DisplaysinformationforaspecificMIBview.
subtreeoid‐or‐mibobject (Optional)DisplaysinformationforaspecificMIBsubtreewhen
viewnameisspecified.
volatile|nonvolatile|
read‐only
(Optional)Displaysentriesforaspecificstoragetype.