Enterasys SecureStack C2 C2G170-24

show cos unit
11-34 Policy Classification Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheCoSinboundratelimitingreferenceconfigurationforall
groups:
C2(su)->clear cos reference irl all
show cos unit
UsethiscommandtoshowpossibleCoSunitentries.
Syntax
show cos unit [irl [port-type index] [kbps]] [flood-ctrl [port-type index] [pps]]
Parameters
Defaults
Ifnoparametersareentered,allCosunitinformationisdisplayed.
Mode
Switchcommand,read‐only.
Examples
Thisexampleshowspossibleunitentriesforinboundratelimiting:
C2(su)->show cos unit irl
Type: Unit:
irl = inbound rate limiting Kbps = Kilobits per second
group‐type‐index Specifiesaninboundratelimiting portgroup/typeindex.Validentriesare
intheformofgroup#.port‐type.
Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type
canrangefrom0to1,althoughonlyporttype0iscurrentlysupported.
Forexample,
portgroup3wouldbespecifiedas3.0.
reference Clearaspecificreferenceforthespecifiedportgroup.
irl (Optional)DisplayonlyIRLunitinformation.
port‐typeindex (Optional)Displayinformationaboutthespecifiedporttype.(Only
port‐typeindex0issupported.)
kbps (Optional)Displaykbpsinformation.
flood‐ctrl (Optional)Displayonlyfloodcontrolunitinformation.
pps (Optional)Displayppsinformation.