To Next Page

To Previous Page

set ciscodp holdtime

6-10 Discovery Protocol Configuration

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtosettheCiscoDPtimerto120second s.

C2(su)->set ciscodp timer 120

set ciscodp holdtime

Usethiscommandtosetthetimetolive(TTL)forCiscodiscoveryprotocolPDUs.Thisisthe

amountoftime,insecond s,neighboringdeviceswillholdPDUtransmissionsfromthesending

device.

Syntax

set ciscodp holdtime hold-time

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtosetCiscoDPholdtimeto180seconds:

C2(su)->set ciscodp hold-time 180

set ciscodp port

Usethiscommandtosetthestatus,voiceVLAN,extendedtrustmode,andCoSpriorityfor

untrustedtrafficfortheCiscoDiscoveryProtocolononeormoreports.

Syntax

set ciscodp port {[status {disable | enable}] [vvid {vlan-id | none | dot1p |

untagged}] [trusted {yes | no}] [cos value]} port-string

seconds SpecifiesthenumberofsecondsbetweenCiscoDPPDU transmissions.

Validvaluesarefrom5to254seconds.

hold‐time SpecifiesthetimetoliveforCiscoDPPDUs.Validvaluesarefrom10to255

seconds.

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24