Enterasys SecureStack C2 C2G170-24 - Using SNMP Contexts to Access Specific Mibs; Configuration Considerations; Reviewing SNMP Statistics; Purpose

Reviewing SNMP Statistics
SecureStack C2 Configuration Guide 8-3
Using SNMP Contexts to Access Specific MIBs
Bydefault,whenoperatingfromtheswitchCLI,SecureStackC2devicesallowaccesstoallSNMP
MIBsorcontexts.AcontextisacollectionofMIBobjects,oftenassociatedwithaparticular
physicalorlogicaldevice.
Ifnooptionalcontextparametersareconfiguredforv1andv2“community”namesandv3
“user”
groups,thesegroupsareabletoaccessallSNMPMIBobjectswheninswitchmode.
SpecifyingacontextparameterwhensettingupSNMPusergroupwouldpermitorrestrictthe
group’sswitchmanagementaccesstotheMIB(s)specifiedbythecontext(MIBobjectID)value.
AllSNMPcontextsknownto
thedevicecanbedisplayedusingtheshowsnmpcontextcommand
asdescribedin“showsnmpcontext”onpage 8‐20.
Example
Thisexamplepermitsthe“powergroup”tomanageallMIBsviaSNMPv3:
C2(su)->set snmp access powergroup security-model usm
Configuration Considerations
CommandsforconfiguringSNMPontheSecureStackC2deviceareindependentduringthe
SNMPsetupprocess.Forinstance,targetparameterscanbespecif iedwhensettingupoptional
notificationfilters—eventhoughtheseparametershavenotyetbeencreatedwiththesetsnmp
targetparamscommand.
Reviewing SNMP Statistics
Purpose
ToreviewSNMPstatistics.
v3 NoAuthNoPriv User name None Uses a user name match for
authentication.
AuthNoPriv MD5 or SHA None Provides authentication based on
the HMAC-MD5 or HMAC-SHA
algorithms.
authPriv MD5 or SHA DES Provides authentication based on
the HMAC-MD5 or HMAC-SHA
algorithms. Provides DES 56-bit
encryption in addition to
authentication based on the CBC-
DES (DES-56) standard.
Table 8-1 SNMP Security Levels (Continued)
Model Security Level Authentication Encryption How It Works