show ip pimsm rp
20-56 IPv4 Routing Protocol Configuration
Parameters
Mode
Anyroutermode.
Defaults
IftheVLANidisomitted,allneighborsoffallinterfaceswillbedisplayed.
Example
ThisexampleshowshowtodisplayPIMinformation:
C2(su)->router> show ip pimsm neighbor
NEIGHBOR TABLE
Vlan ID IP Address Up Time Expiry Time
(hh:mm:ss) (hh:mm:ss)
--------- ---------------- ---------- ------------
30 192.168.30.2 01:36:41 00:01:25
6 192.168.6.1 01:36:41 00:01:25
Table 20‐11providesanexplanationofthecommandoutput.
show ip pimsm rp
ThiscommanddisplaysthePIMinformationforcandidateRendezvousPoints(RPs)forallIP
multicastgroupsorforaspecificgroupaddress.Theinformationinthetableisdisplayedforeach
IPmulticastgroup.
Syntax
show ip pimsm rp {group-address group-mask | all | candidate}
Parameters
vlan‐id (Optional)DisplayallneighborsdiscoveredonaspecificInterface.
Table 20-11 show ip pimsm neighbor Output Details
Output Field What it displays
Vlan ID VLAN id of the interface.
IP Address The IP Address of the neighbor on an interface
Up Time The time since this neighbor has become active on this interface.
Expiry Time The expiry time of the neighbor on this interface.
group‐address ThemulticastgroupIPaddress.
group‐mask Themulticastgroupaddresssubnetmask.
all Forallknowngroupaddresses.
candidate DisplayPIM‐SMcandidate‐RPtableinformation.
To Next Page
Need help?
General