Enterasys SecureStack C2 C2G170-24

ip pimsm enable
SecureStack C2 Configuration Guide 20-51
Parameters
Defaults
None.
Mode
GlobalRouterconfiguration:C2(su)‐>router(Config)#
Example
ThisexampleshowshowtosetanRPforaspecificmulticastgroup.
C2(su)->router(Config)# ip pimsm staticrp 192.15.18.3 224.0.0.0 240.0.0.0
ip pimsm enable
ThiscommandsetstheadministrativemodeofPIM‐SMmulticastroutingonaroutinginterfaceto
enabled.Bydefault,PIMisdisabledonallIPinterfaces.Thenoformofthiscommanddisables
PIMonthespecificinterface.
Syntax
ip pimsm enable
no ip pimsm enable
Parameters
None.
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenablePIMonIPinterfaceforVLAN1.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm enable
ipaddress TheIPaddressoftheRendezvousPoint
groupadress ThegroupaddresssupportedbytheRendezvousPoint
groupmask Thegroupmaskforthegroupaddress