Enterasys SecureStack C2 C2G170-24

set igmpsnooping interfacemode
13-4 IGMP Configuration
Example
ThisexampleshowshowtoenableIGMPonthesystem:
C2(su)->set igmpsnooping adminmode enable
set igmpsnooping interfacemode
UsethiscommandtoenableordisableIGMPononeorallports.
Syntax
set igmpsnooping interfacemode port-string {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
InorderforIGMPsnoopingtobeenabledononeorallports,itmustbegloballyenabledonthe
deviceusingtheset igmpsnoopingadminmodecommandasdescribedin“setigmpsnooping
adminmode”onpage 13‐3,and thenenabledonaport(s)usingthiscommand.
Example
ThisexampleshowshowtoenableIGMPonportge.1.10:
C2(su)->set igmpsnooping interfacemode ge.1.10 enable
set igmpsnooping groupmembershipinterval
UsethiscommandtoconfiguretheIGMPgroupmembershipintervaltimeforthesystem.
Syntax
set igmpsnooping groupmembershipinterval time
Note: IGMP snooping cannot be controlled via WebView.
port‐string SpecifiesoneormoreportsonwhichtoenableordisableIGMP.
enable|disable EnablesordisablesIGMP.