Enterasys SecureStack C2 C2G170-24 - Set Port Duplex

set port duplex
7-12 Port Configuration
Example
ThisexampleshowshowtodisplaythedefaultduplexsettingforEtherne tport14inslot 3:
C2(su)->show port duplex ge.3.14
default duplex mode is full on port ge.3.14.
set port duplex
Usethiscommandtosetthedefaultduplextypeforoneormoreports.Thiscommandwillonly
takeeffectonportsthathaveauto‐negotiationdisabled.
Syntax
set port duplex port-string {full | half}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetge.1.17tofullduplex:
C2(su)->set port duplex ge.1.17 full
port‐string Specifiesthe port(s)forwhichduplextypewillbeset.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage7‐2.
full|half Setstheport(s)tofull‐duplexorhalf‐duplexoperation.