Enterasys SecureStack C2 C2G170-24

Configuring Simple Network Time Protocol (SNTP)
SecureStack C2 Configuration Guide 14-27
Example
Thisexampleenablesmulticastfloodprotection.
C2(su)->set mac unreserved-flood enable
Configuring Simple Network Time Protocol (SNTP)
Purpose
ToconfiguretheSimpleNetworkTimeProtocol(SNTP),whichsynchronizesdeviceclocksina
network.
Commands
show sntp
UsethiscommandtodisplaySNTPclientsettings.
Syntax
show sntp
Parameters
None.
Note: A host IP address must be configured on the C2 to support SNTP.
For information about... Refer to page...
show sntp 14-27
set sntp client 14-29
clear sntp client 14-29
set sntp server 14-30
clear sntp server 14-30
set sntp poll-interval 14-31
clear sntp poll-interval 14-31
set sntp poll-retry 14-32
clear sntp poll-retry 14-32
set sntp poll-timeout 14-33
clear sntp poll-timeout 14-33
set timezone 14-33