Enterasys SecureStack C2 C2G170-24

set port disable
SecureStack C2 Configuration Guide 7-7
Commands
set port disable
Usethiscommandtoadministrativelydisableoneormoreports.Whenthiscommandis
executed,inadditiontodisablingthephysicalEthernetlink,theportwillnolongerlearnentries
intheforwardingdatabase.
Syntax
set port disable port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisablege.1.1:
C2(su)->set port disable ge.1.1
set port enable
Usethiscommandtoadministrativelyenableoneormoreports.
Syntax
set port enable port-string
Parameters
Defaults
None.
For information about... Refer to page...
set port disable 7-7
set port enable 7-7
show port alias 7-8
set port alias 7-8
port‐string Specifiestheport(s)todisable.Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntaxUsedintheCLI”onpage7‐2.
port‐string Specifiestheport(s)toenable.Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntaxUsedintheCLI”onpage7‐2.