show snmp targetparams
SecureStack C2 Configuration Guide 8-23
Parameters
Defaults
IftargetParamsisnotspecified,entriesassociatedwithalltargetparameterswillbedisplayed.
Ifnotspecified,entriesofallstoragetypeswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaySNMPtargetparametersinformation:
C2(su)->show snmp targetparams
--- SNMP TargetParams information ---
Target Parameter Name = v1ExampleParams
Security Name = public
Message Proc. Model = SNMPv1
Security Level = noAuthNoPriv
Storage type = nonVolatile
Row status = active
Target Parameter Name = v2cExampleParams
Security Name = public
Message Proc. Model = SNMPv2c
Security Level = noAuthNoPriv
Storage type = nonVolatile
Row status = active
Target Parameter Name = v3ExampleParams
Security Name = CharlieDChief
Message Proc. Model = USM
Security Level = authNoPriv
Storage type = nonVolatile
Row status = active
Table 8‐8providesanexplanationofthecommandoutput.
targetParams (Optional)Displaysentriesforas pecifictargetparameter.
volatile|nonvolatile|
read‐only
(Optional)Displaystargetparameterentriesforaspecificstorage
type.
Table 8-8 show snmp targetparams Output Details
Output Field What It Displays...
Target Parameter Name Unique identifier for the parameter in the SNMP target parameters table.
Maximum length is 32 bytes.
Security Name Security string definition.
Message Proc. Model SNMP version.
Security Level Type of security level (auth: security level is set to use authentication
protocol, noauth: security level is not set to use authentication protocol,
or privacy).
Storage type Whether entry is stored in volatile, nonvolatile or read-only memory.
Row status Status of this entry: active, notInService, or notReady.
To Next Page
Loading...
Need help?
General