Enterasys SecureStack C2 C2G170-24

clear dhcp pool
16-14 DHCP Server Configuration
clear dhcp pool
UsethiscommandtodeleteaDHCPserverpoolofaddresses.
Syntax
clear dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheaddresspoolnamed“auto1.”
C2(rw)->clear dhcp pool auto1
set dhcp pool network
UsethiscommandtoconfigurethesubnetnumberandmaskforanautomaticDHCPaddress
pool.
Syntax
set dhcp pool poolname network number {mask | prefix-length}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
UsethiscommandtoconfigureasetofIPaddressestobeassignedbytheDHCPserverusingthe
specifiedaddresspool.Inordertolimitthescopeoftheaddressesconfiguredwiththiscommand,
usethesetdhcpexcludecommandonpage16‐7.
poolname Specifiesthenameofthe
addresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
number SpecifiesanIPsubnetfortheaddresspool.
mask Specifiesthesubnetmaskindottedquadnotation.
prefix‐length Specifiesthesubnetmaskasaninteger.