Enterasys SecureStack C2 C2G170-24 - Ip Pimsm; Ip Pimsm Staticrp

ip pimsm
20-50 IPv4 Routing Protocol Configuration
ip pimsm
ThiscommandsetsadministrativemodeofPIM‐SMmulticastroutingacrosstherouterto
enabled.IGMPmustbeenabledbeforePIM‐SMcanbeenabled.Bydefault,bothIGMPandPIM
aregloballydisabled.ThenoformofthiscommanddisablesPIM(acrosstheentirestack,if
applicable).
Syntax
ip pimsm
no ip pimsm
Parameters
None.
Defaults
None.
Mode
Globalrouterconfiguration:C2(su)‐>router(Config)#
Example
ThisexampleshowshowtogloballyenableanddisablePIM:
C2(su)->router(Config)# ip pimsm
C2(su)->router(Config)# no ip pimsm
ip pimsm staticrp
ThiscommandisusedtocreateamanualRendezvousPointIPaddressforthePIM‐SMrouter.
ThenoformofthiscommandremovesapreviouslyconfiguredRP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
show ip pimsm interface 20-54
show ip pimsm neighbor 20-55
show ip pimsm rp 20-56
show ip pimsm rphash 20-57
show ip pimsm staticrp 20-58
show ip mroute 20-59
For information about... Refer to page...