Enterasys SecureStack C2 C2G170-24

Using and Configuring WebView
3-50 Basic Configuration
Example
Thisexampleshowshowtoclearconfigurationparameters(includingstackingparameters,if
applicable):
C2(su)->clear config all
Using and Configuring WebView
Purpose
Bydefault,WebView(TheEnterasysNetworksembeddedwebserverforswitchconfiguration
andmanagementtasks)isenabledonTCPportnumber80ontheSecureStackC2switch.Youcan
verifyWebViewstatus,andenableordisableWebViewusingthecommandsdescribedinthis
section.WebViewcanalsobesecurelyusedover
SSLport443,ifSSLisenabledontheswitch.By
default,SSLisdisabled.
TouseWebView ,typetheIPaddressoftheswitchinyourbrowser.TouseWebViewoverSSL,
typeinhttps://thentheIPaddressoftheswitch.Forexample,https://172.16.2.10.
Commands
show webview
UsethiscommandtodisplayWebViewstatus.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show webview 3-50
set webview 3-51
show ssl 3-51
set ssl 3-52