show ciscodp port info
6-8 Discovery Protocol Configuration
Device ID : 001188554A60
Last Change : WED NOV 08 13:19:56 2006
Table 6‐2providesanexplanationofthecommandoutput.
show ciscodp port info
UsethiscommandtodisplaysummaryinformationabouttheCiscodiscoveryprotocolononeor
moreports.
Syntax
show ciscodp port info [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,CiscoDPinformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayCiscoDPinformationforGigabitEthernetport1inslot1.
C2(su)->show ciscodp port info ge.1.1
port state vvid trusted cos
----------------------------------------------
ge.1.1 enable none yes 0
Table 6‐3providesanexplanationofthecommandoutput.
Table 6-2 show ciscodp Output Details
Output Field What It Displays...
CiscoDP Whether Cisco DP is globally enabled or disabled. Auto indicates that Cisco DP will
be globally enabled only if Cisco DP PDUs are received.
Default setting of auto-enabled can be reset with the set ciscodp status command.
Timer The number of seconds between Cisco discovery protocol PDU transmissions. The
default of 60 seconds can be reset with the set ciscodp timer command.
Holdtime Number of seconds neighboring devices will hold PDU transmissions from the
sending device. Default value of 180 can be changed with the set ciscodp holdtime
command.
Device ID The MAC address of the switch.
Last Change The time that the last Cisco DP neighbor was discovered.
port‐string (Optional)DisplaysCiscoDPinformationforaspecificport.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage7‐2.
To Next Page
Loading...
Need help?
General