Enterasys SecureStack C2 C2G170-24

clear macauthentication portquietperiod
SecureStack C2 Configuration Guide 23-27
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsport1towait5secondsafterafailedauthenticationattemptbeforeanew
attemptcanbemade:
C2(su)->set macauthentication portquietperiod 5 ge.1.1
clear macauthentication portquietperiod
Thissetsthequietperiodbacktothedefaultvalueof30seconds.
Syntax
clear macauthentication portquietperiod [port-string]
Parameters
Defaults
Ifaport‐stringisnotspecifiedthenallportswillbesettothedefaultportquietperiod.
Mode
Switchcommand,read‐write.
Example
Thisexampleresetsthedefaultquietperiodonport1:
C2(su)->clear macauthentication portquietperiod ge.1.1
set macauthentication macinitialize
UsethiscommandtoforceacurrentMACauthenticationsessiontore‐initializeandremovethe
session.
Syntax
set macauthentication macinitialize mac-addr
Parameters
port‐string (Optional)Specifiestheportsforwhichthequietperiodistobereset.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 7‐2.
mac‐addr SpecifiestheMACaddressofthesessiontore‐initialize.