To Next Page

To Previous Page

set rmon alarm properties

15-10 RMON Configuration

set rmon alarm properties

UsethiscommandtoconfigureanRMONalarmentry,ortocreateanewalarmentrywithan

unusedalarmindexnumber.

Syntax

set rmon alarm properties index [interval interval] [object object] [type

{absolute | delta}] [startup {rising | falling | either}] [rthresh rthresh]

[fthresh fthresh] [revent revent] [fevent fevent] [owner owner]

Parameters

Table 15-2 show rmon alarm Output Details

Output Field What It Displays...

Index Index number for this alarm entry.

Owner Text string identifying who configured this entry.

Status Whether this event entry is enabled (valid) or disabled.

Variable MIB object to be monitored.

Sample Type Whether the monitoring method is an absolute or a delta sampling.

Startup Alarm Whether alarm generated when this entry is first enabled is rising, falling, or either.

Interval Interval in seconds at which RMON will conduct sample monitoring.

Rising Threshold Minimum threshold for causing a rising alarm.

Falling Threshold Maximum threshold for causing a falling alarm.

Rising Event Index Index number of the RMON event to be triggered when the rising threshold is

crossed.

Falling Event Index Index number of the RMON event to be triggered when the falling threshold is

crossed.

index Specifiesanindexnumberforthisentry.Maximumnumberorentriesis

50.Maximumvalueis65535.

intervalinterval (Optional)Specifiesaninterval(inseconds)forRMONtoconductsample

monitoring.

objectobject (Optional)SpecifiesaMIBobjecttobemonitored.

Note: This parameter is not mandatory for executing the command, but

must be specified in order to enable the alarm entry configuration.

typeabsolute|

delta

(Optional)Specifiesthemonitoringmethodas:samplingtheabsolute

valueoftheobject,orthedifference(delta)betweenobjectsamples.

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24