To Next Page

To Previous Page

set sntp server

14-30 Logging and Network Management

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtocleartheSNTPclient’soperationalmode:

C2(su)->clear sntp client

set sntp server

UsethiscommandtoaddaserverfromwhichtheSNTPclientwillretrievethecurrenttimewhen

operatinginunicastmode.Upto10serverscanbesetasSNTPservers.

Syntax

set sntp server ip-address [precedence]

Parameters

Defaults

Ifprecedenceisnotspecified,1willbeapplied.

Mode

Switchcommand,read‐write.

Example

ThisexampleshowshowtosettheserveratIPaddress10.21.1.100 asan SNTPserver:

C2(su)->set sntp server 10.21.1.100

clear sntp server

UsethiscommandtoremoveoneorallserversfromtheSNTPserverlist.

Syntax

clear sntp server {ip-address | all}

Parameters

Defaults

None.

ip‐address SpecifiestheSNTPserver’sIPaddress.

precedence (Optional)SpecifiesthisSNTPserver’sprecedenceinrelationtoitspeers.

Validvaluesare1(highest)to10(lowest).

ip‐address SpecifiestheIPaddressofaservertoremovefromthe SNTPserverlist.

all RemovesallserversfromtheSNTPserverlist.

Enterasys SecureStack C2 C2G170-24 User Manual

Other manuals for Enterasys SecureStack C2 C2G170-24