Enterasys SecureStack C2 C2G170-24 - Ip Pimsm Query-Interval; Show Ip Pimsm

ip pimsm query-interval
20-52 IPv4 Routing Protocol Configuration
ip pimsm query-interval
Thiscommandconfiguresthetransmissionfrequencyofhellomessagesinsecondsbetween
PIM‐enabledneighbors.Thenoformofthiscommandresetsthehellointervaltothedefault,30
seconds.
Syntax
ip pimsm query-interval seconds
no ip pimsm query-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
Thisexampleshowshowtosetthehellointervalrateto100seconds.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm query-interval 100
show ip pimsm
Usethiscommandtodisplaysystem‐widePIM‐SMroutinginformation.
Syntax
show ip pimsm
Parameters
None.
Defaults
None.
Mode
Anyroutermode.
Example
ThisexampleshowshowtodisplayPIMinformation.
C2(su)->router# show ip pimsm
Admin Mode Enable
Join/Prune Interval (secs) 60
seconds Thisfieldhasarangeof10to3600seconds.Defaultis30.