Enterasys SecureStack C2 C2G170-24

create
SecureStack C2 Configuration Guide 20-43
Usage
Youmustexecutetheroutervrrpcommandtoenabletheprotocolbeforecompletingother
VRRP‐specificconfigurationtasks.Fordetailsonenablingconfigurationmodes, refertoTable 18‐2
onpage 18‐2.
Example
ThisexampleshowshowenableVRRPconfigurationmode:
C2(su)->router#configure
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#
create
UsethiscommandtocreateaVRRPsession.EachSecureStackC2systemsupportsupto20VRRP
sessions.ThenoformofthiscommanddisablestheVRRPsession.
Syntax
create vlan vlan-id vrid
no create vlan vlan-id vrid
Parameters
Defaults
None.
Mode
Router configuration: C2(su)->router(Config-router)#
Usage
ThiscommandmustbeexecutedtocreateaninstanceofVRRPonaroutingint erface(VLAN)
beforeanyotherVRRPsettingscanbeconfigured.
Example
ThisexampleshowshowtocreateaV RRPsessionontheVLAN1interfacewithaVRIDof1:
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#create vlan 1 1
vlanvlan‐id SpecifiesthenumberoftheVLANonwhichtocreate aVRRPsession.This
VLANmustbeconfiguredforIProutingasdescribedin“Pre‐Routing
ConfigurationTasks”onpage18‐1.
vrid SpecifiesauniqueVirtualRouterID(VRID)toassociatewiththerouting
interface.