Siemens Hicom 150 E Office - Page 353

10 77 to 87 Project code entered by the user for this call:
ppppppppppp
(p = project code digit: value range 0 ... 9)
If a project code was not entered, 11 blanks are
output. If the project code is shorter than 11
positions, the remaining positions are filled
with blanks.
11 Left
11 88 to 98 MSN used: mmmmmmmmmmm
(m = digits for the MSN: value range 0 ... 9)
This is displayed if the subscriber has
programmed an MSN key. Digits not available
are replaced by leading blanks. If MSN
information is not available (e.g. PtP
connection), 11 blanks are output instead of
these characters.
11 Right
12 99 to 103 Seizure code used, access code: bbbbb
(b = digits for seizure code: value range 0 ... 9)
Characters not available are replaced with
leading blanks.
5 Right
13 104 to
105
LCR route available: rr
(r = digit of dialled route: value range 0 ... 9)
Characters not available are replaced with
leading blanks.
2 Right
14 106 bis
107
PRI Nodal Service: nn
(n = Ziffer: Wertebereich 0 ... 9)
Nicht vorhandene Stellen werden durch
führende Blanks ersetzt.
2 Rechts
15 108 PRI WATS-Band: w
(w = Ziffer: Wertebereich 0 ... 9)
Liegt keine Information vor, wird ein Blank
ausgegeben.
1 -
16 109 bis
112
PRI Carrier Identification Code CIC: cccc
(c = Ziffer des CIC: Wertebereich 0 ... 9)
Nicht vorhandene Stellen werden durch
führende Blanks ersetzt.
4 Rechts
14 106 to
107
USA-specific fields are filled with blanks. 2 Right
15 108 1 -
16 109 to
112
4 Right
17 113 to
114
End-of-line control characters
(Carriage Return CR, Line Feed LF)
2 -
Hicom 150 E Office Rel.1.0 Service Manual - 7.12 Features for Call Detail Recording
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_712.htm (18 of 21) [06/04/2000 13:08:19]