Siemens Hicom 150 E Office - Page 375

Electronic directory
Requirements
Pentium PC with 586 CPU and 90 MHz
16 MB RAM
Super VGA with a resolution of 800x600 pixels
Sound card with loudspeakers
Free RS-232 interface (COM1-COM4)
Windows 95 operating system
Font size: normal fonts
Hicom 150 E Office system (Version 1.0 and later)
Connection via
- U
P0/E
PC card
or
- optiset E memory or optiset E comfort
with
optiset E control adapter or optiset E data adapter
Headset, optional
Connection to the system
If Then
Connection via
U
P0/E
PC card
Connect Hicom Attendant P (PC AC, PC attendant) directly to the PC's V.24
interface.
Connection via
optiset E memory
or
optiset E comfort
with
control adapter
or
data adapter
Connect Hicom Attendant P (PC AC, PC attendant console) to the V.24 interface
in parallel to an optiset E terminal via the optiset E adapter. The terminal retains
its full functionality.
Call indication at the terminal is switched off by activating the ringer cutoff
system feature when logging on the PC AC at the system. This procedure can be
administered under "Settings". The same applies to the silent camp-on feature.
The associated terminal must be configured as an "attendant".
The hardware configuration of Hicom Attendant P both via the optiset E terminal and via a U
P0/E
PC
card is described in detail in the Hicom Attendant P for Hicom 150 E Office Administrator Manual.
The "Hicom Attendant P for Hicom 150 E Office (Release 1.0)" accessory pack included in the scope
of supply includes this administrator manual as well as an operating manual that contains detailed
information about the use of Hicom Attendant P (see List of documentation).
Hicom 150 E Office Rel.1.0 Service Manual - 10 Special equipment
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_10.htm (16 of 17) [06/04/2000 13:08:50]