Table 2, Line 1: Route: 1, Dial rule: 2 (local calls via Telekom, 24 hours a day since no schedule was
entered)
Table 3, Line 1: Route: 1, Dial rule: 3, Schedule: A (all other calls via Mobilcom)
Table 3, Line 2: Route: 1, Dial rule: 2, Schedule: A (all other calls via Telekom)
Table 3, Line 3: Route: 1, Dial rule: 2, Schedule: B (all other calls via Telekom)
Table 3, Line 4: Route: 1, Dial rule: 3, Schedule: C (all other calls via Mobilcom)
Table 3, Line 5: Route: 1, Dial rule: 2, Schedule: C (all other calls via Telekom)
Switch to the window Least cost routing/LCR - schedule and make the following entries:
Day: Monday: Time limit 1: 01:59, Zone 1: A (time from 00:00 to 01:59, Telekom/Mobilcom)
Day: Monday: Time limit 2: 04:59, Zone 2: B (time from 02:00 to 04:59, Telekom)
Day: Monday: Time limit 3: 08:59, Zone 3: A (time from 05:00 to 08:59, Telekom/Mobilcom)
Day: Monday: Time limit 4: 17:59, Zone 4: C (time from 09:00 to 17:59,
Telekom/Mobilcom/Telepassport)
Day: Monday: Time limit 5: 23:59, Zone 5: A (time from 18:00 to 23:59, Telekom/Mobilcom)
Time limits 1, 3 and 5 can be combined in zone A in this network supplier and time scenario. This is
possible since Telekom and Mobilcom can operate as carriers in all three time limits.
The time limits and zones are to be transferred to the days Tuesday to Sunday.
Switch to the window Least cost routing/Dialling rules table and make the following entries:
Line 1: Rule name: Telepassport, Rule format: D01024A, Procedure: C&W single-stage
Line 2: Rule name: Telekom, Rule format: A, Procedure: Main network supplier
Line 3: Rule name: Mobilcom, Rule format: D01019A, Procedure: C&W single-stage
Using the master system's system speed-dialling from the slave system
Prerequisites for programming example
Only the master system has no trunk access.
System speed-dialling can be used in the case of both open and closed numbering.
Extensions in the slave system dial 77 and the 3-digit system speed-dialling number, extensions in the
master system dial *7 and the 3-digit system speed-dialling number.
Programming the master system
Programming steps as described under "Closed numbering with break out in the master system via
LCR".
Slave system
Programming steps as described under "Closed numbering with break out in the master system via
http://cmweb01.mch.pn.siemens.de/e_doku/en/h150/h15/30/sh/2/15_815.htm (12 of 13) [06/04/2000 13:12:59]
To Next Page
Loading...
