3-14
3
Change PIN
Log In > Change PIN
The PIN number IS NOT the User Log In ID number (1st number entered during log in).
The User’s PIN number is the secondary number used for log in.
The User will be prompted to enter the current PIN number before a new PIN number can be
entered.
Clear Errors
Log In > Status > Coin Recycler
This function can be used to clear/reset existing errors.
Close Gaming Session Early
Not applicable at this time.
Coin Exchange
Log In > Status (bottom tool bar) > Coin Recycler > Coin Exchange
This function can be used to adjust the coin count in the Hoppers.
- + Will decrease/increase count by “1”
-- ++ Will decrease/increase coin count by 10
--- +++ Will decrease/increase coin count by 100
DONE - coin count changes are saved and cannot be reset (unless re-entered).
EMPTY - sets the selected Hopper count to “0”
RESET - returns the altered count of the selected Hopper to the original coin count prior to making
changes (will not reset if DONE was selected after making changes)
RESET ALL - returns the altered count of the selected Hopper to the original coin count prior to
making changes (will not reset if DONE was selected after making changes)
Coin Acceptor
Log In > Configuration Menu > Edit Configuration > Device Configuration > Coin Recycler
Configuration > Coin Acceptor
Used to set the type of Coin Sorter being used with the TR Series Recycler.
Mach 6 = TR Series default type Coin Sorter.
None = No Coin insertion menus will be visible.
To Next Page
Loading...