1-3
1
Coin Handler Cabinet Dimensions:
Depth: 36.19” (919 mm) 2” space suggested behind the unit for cabling
Width: 25” (635 mm)
Height: 49.5” (1257 mm)
Height 64” (1626 mm) Cover lifted
Weight: 854 lbs (387 kg)
Front Clearance - 31” from front of Coin Handler Vault for full Coin Hopper Rack extension.
Total Depth Clearance - 67” from rear of Coin Handler.
Power Requirements:
Voltage - 100 – 240 VAC
Amperage - 6 AMP maximum
Frequency – 50/60 Hz, 3 wire – single phase
The TR253 must be connected to a dedicated, earthed ground mains socket-outlet that meets all
applicable electrical codes.
The dedicated circuit must consist of a LINE, NEUTRAL and EARTHED GROUND, connected directly
to the power distribution panel and cannot share the same conduit as other equipment.
Additional protection is recommended by connecting to a commercial grade GFCI device, which
meets local electrical codes, at the electrical panel.
The equipment should be installed near a socket/outlet which is easily accessible.
To completely remove power, disconnect the plug from the socket/outlet.
Cabinet Construction – ¼” thick, (6.350 mm), welded steel.
Door Construction – ¼” thick, (6.350 mm), steel.
Operating Temperature range - 60 ~ 90 degrees Fahrenheit
Storage Temperature range - 0 ~ 125 degrees Fahrenheit
Coin Sorter mechanism:
Voltage - 100 – 240 VAC
Amperage - 4 AMP
Fuse location: Rear panel, above power cord receptacle
Coin Handler Specifications
To Next Page
Loading...
