13-2
13
The Rolled Coin Dispenser Remote Module is protected by a resettable 2 amp thermal breaker which
also serves as an ON/OFF Switch (located in the top, left corner of the cabinet).
The Rolled Coin Dispenser Module is equipped with 4 Dispensers which vend rolls of coins.
An additional Rolled Coin Dispenser Module can be connected to the primary (1st), Rolled Coin
Dispenser Module for a total of (8) rolled coin dispensers.
Dispenser Magazine Capacities (USD):
.01 = 160 rolls .05 = 130 rolls
.10 = 180 rolls .25 = 100 rolls
Load magazines with MACHINE ROLLED COINS ONLY !
A +12 VDC motor turns a Cradle in the bottom of the Magazine, which is sized for specific coin
denominations.
The same Dispenser is used for pennies, nickels and dimes, while the Dispenser for quarters is different
A Sensor at the Dispenser exit detects the rolls of coins as they are vended from the Magazine into a
Receiving Tray.
Note: If the number of rolls requested exceeds the receiving tray capacity, the user will be required to
remove coin rolls from the tray to proceed.
Receiving Tray capacities:
.01 = 5 rolls .05 = 5 rolls
.10 = 6 rolls .25 = 4 rolls
Dispensers can be replaced individually, but with the exception of cleaning or removing jams, are not
field serviceable.
Dispensing Sequence
When 2 or more dispensers are assigned the same coin denomination:
X The request will be dispensed from the Dispenser with the highest Rolled Coin Count
X When Rolled Coin Counts are equal, the Dispenser will alternate after each dispense
request (after each coin roll dispense)
X If a Dispenser runs empty during a dispense request, the dispense will be completed
from another Dispenser of the same denomination (will NOT dispense from a different
denomination Dispenser).
When all dispensers are assigned a different coin denomination:
X The Dispenser will dispense from the lowest to highest coin denomination
Rolled Coin Dispenser General Information
To Next Page
Loading...