3-16
3
Coin Recycler Configuration
Log In > Configuration Menu > Edit Configuration > Device Configuration > Coin Recycler
Configuration
Provides access to the Coin Handler Setup:
X LAN Connection
Local = Coin Handler is connected directly to the TR Series computer.
No Device = TR Series will not contain any coin recycling menus.
Simulator = Allows the manufacturer to perform testing when a Coin Recycler is not
actually connected to the TR Series (not for field use).
X Coin Acceptor
Mach 6 = TR Series default type Coin Sorter.
None = No Coin insertion menus will be available .
X Hopper Configuration
Increasing default amounts from factory settings is not recommended.
Coin Hopper layout is determined by the setup of the Coin Sorter.
Coin Hopper denominations/locations can only be changed by modifying the Coin
Sorter setup.
Hopper Enable/Disable
Enabled = The Hopper will accessible when programming mixes
Disabled = Hopper cannot be included when programming mixes
Dispensable Enable/Disable - determines if coins will be dispensed from Hoppers
Capacity
Cup Size - determines how many coins can be deposited in the Coin Collection Tray
before removal/empty is required.
X Cold Start BCR
Clears the Coin Acceptor Setup and Coin Counts.
Hopper and Coin Collection Tray capacities will be set to default amounts.
Coins In
Log In > Status (bottom tool bar) > Coin Recycler > Dump Accept > Coins In
The intended purpose of this feature is to verify Coin Hopper amounts.
Coins being added for normal operations should be loaded using the CASH IN function.
Performing an “accept” (coins in), will produce a report indicating the beginning counts, ending
counts and the “coin out/coin in” net difference.
Coins inserted using this feature do not effect Register or Overflow Bin amounts.
ACCEPT (Coins in) = The Coin Sorter will operate, allowing coins to deposited into the Hoppers.
To Next Page
Loading...