11-20
11
Note Recycler installation
Step 1: Position the Note Recycler assembly back into the cabinet opening and route the wiring
harness into the electronics bay.
WARNING - Insure the Note Recycler is seated fully into the TR250 cabinet
Place a Cradle retaining bracket “C” and insure the anchor mounting hole and
Recycler frame are aligned before proceeding
If not pull the Note Recycler out about 1/2 way and attempt to reinstall it in
the TR250 cabinet.
Step 2: Secure the Note Recycler Cradle into the cabinet using the retaining brackets “B” and engage
the caster brakes.
Step 3 Install the (2) Cradle brackets “C” onto the front of the Cradle Frame with the phillips head
screws (do not tighten fully).
Step 4: Secure the Cradle brackets with the (2) front anchor bolts and tighten the phillips head screws
on the Cradle frame.
Step 5: Install the Note Recycler retaining bracket “A” to the upper/front/left of the Note Recycler.
Step 6: Install the 2 remaining screws on the outsides of the brackets “C”
Step 7: Locate the Cash Handler wiring harness inside the electronics bay (on the front/right side) and
reconnect the following:
a) The LOWER connector on the front side of the Power Supply.
b) The USB cable on the front side of the PC assembly.
A
B
Caster “brakes” Caster “brakes”
B
C
C
Note Recycler +24VDC
and Data cable harness
To Next Page
Loading...
