6-9
6
Intermittent Resets/Reboots
1) Check for the presence of an Isolated Circuit, Surge Protector or UPS type device and insure all
cabling is connected securely .
2) Check the condition of the Power Cord and insure it is secured at the rear of the unit.
3) Check the condition of the ON/OFF switch - 6 amp Circuit Breaker (lower/right side of the
Power Supply Assembly).
4) Check the VDC output voltage connector on the right side of the Power Supply Chassis.
5) Check the output voltages of the Power Supples.
If voltages are incorrect, the appropriate Power Supply may be defective or require
adjustment.
Intermittent Coin Dispenser (Hopper) operation
1) Insure the Hoppers are seated securely in the Coin Dispenser (Hopper) rack.
2) Check the +24 VDC output voltage at the Power Supply ouput.
If voltages are incorrect, the +24 VDC Power Supply may be defective or require
adjustment.
3) Possible defective Hardwarew Support PCB.
Power Supply Troubleshooting
To Next Page
Loading...
