14
14-11
Printer
#2 - Roller area - Blow out with compressed air
#1 - Cutter area - Blow out with compressed air
(A) Printer
Clearing Cleaning Odometers
Coin Sorter
1)
2) Navigate to the Coin Recycler Menu.
Log In > Status (bottom tool bar) > Coin Recycler > Perform Maintenance
3) Select the Count for the Coin Acceptor
4) Select “CLEAN” - Verify cleaning was performed when prompted to reset the counter to “0”.
Coin Sorter Odometer set to “0”
Coin Sorter “CLEAN” Odometer count ____________________________________
Note Recycler
1)
2) Navigate to the Coin Recycler Menu.
Log In > Status (bottom tool bar) > Coin Recycler > Perform Maintenance
3) Highlight the “BNR Total” selection under the CLEAN column (DO NOT clear Lifetime or
Maintenance totals).
4) Select “CLEAN” - Verify cleaning was performed when prompted to reset the counter to “0”.
Coin Sorter Odometer set to “0”
Note Recycler “CLEAN” Odometer count ____________________________________
#3 - Roller area - Vacuum entire printer interior
Coin Hoppers
1)
2) Navigate to the Coin Recycler Menu.
Log In > Status (bottom tool bar) > Coin Recycler > Perform Maintenance
3) Select the desired Hopper and choose “CLEAN” (press “skip” to advance to additional hoppers).
4) Verify cleaning was performed - when prompted to reset the counter to “0”.
Coin Hopper Odometers set to “0”
Coin Hopper “CLEAN” Odometer count ____________________________________________________
1 2 3 4 5 6
To Next Page
Loading...
