13-6
13
Configure the Rolled Coin Dispenser
Log In > Cash Control > Configure Dispense Choices > Rolled Coin Dispenser > Setup
Dispensers
a) Select the desired Dispenser.
b) Enable the Dispenser.
Note: A prompt to enable all dispensers will be displayed - select YES if all Dispensers
are to be used.
c) Assign the coin value.
d) Enable dispensing.
e) Select “DONE” to exit and save your settings.
f) Repeat steps “a - e” for all Dispensers being used.
g) Select “DONE” to exit and save your settings.
Configure the dispense choices
Log In > Cash Control > Configure Dispense Choices > Rolled Coin Dispenser > Set
Choices
a) Select an available dispense selection icon.
b) Select the number of Dispensers the rolled coins will be dispensed from (in a single
dispense selection).
c) Select coin denomination type and the number of coins to dispense.
d) Repeat step “C” for each coin denomination type.
e) Enter a description for the selection.
f) Repeat steps “a - e” for all desired dispense selections.
g) Select “DONE” to exit and save your settings.
Manually configuring the Rolled Coin Dispenser
This step is not necessary if “Hardware Detect” was performed during initial setup.
1) Navigate to the Peripheral Menu:
Log In > (enter Executive code) > More > Maintenance > More > Configure > Peripherals
> Rolled Coin Dispenser
a) Select the appropriate settings:
X C (P5)
2) Navigate to the Diagnostics Menu:
Log In > (enter Executive code) > More > Maintenance > Diagnostics > Rolled Coin
Dispenser
a) Select “Reset”
Rolled Coin Dispenser Setup
To Next Page
Loading...