3-83
3
Send All Rejects To Deposit
Log In > Configuration Menu > Edit Configuration > Device Configuration > Note Recycler
Notes rejected during deposit operations are always presented back to the note insertion/
collection area.
Notes rejected during dispense operation are always deposited in the Reject Cassette.
ENABLED:
All notes removed from the Reject Cassette (that can be recognized by the Note Recycler), will
be processed to the Deposit Cassette when re-introduced using the Empty Reject Cassette
function.
Notes that cannot be recognized by the Note Recycler will be presented back to the User
(back to the Note Collection area).
DISABLED:
Notes that can be identified, but are unacceptable are routed to the Deposit Cassette.
Notes that can be identified by the Note Recycler and are acceptable are deposited into the
appropriate Recycle Cassette.
Send Empty TX
Log In > Configuration Menu > Edit Configuration > Network Reports
Report transfers will occur even if no activity has been performed on the unit in the date/time range
of the report.
Send Periodic TX Every...
Log In > Configuration Menu > Edit Configuration > Network Reports
This is the time intervals which report files will be transferred to the designated server
0 - 99999999 minutes
Service Recyclers
Log In > Configuration Menu > Edit Groups, Mixes, etc > Permission Groups > (Select Group)
Users linked to a Group with this ability can
If this function IS NOT ASSIGNED, Users user linked to the Group will not be able to access the
Coin/Note Recycler menus (after logging in and selecting Status)..
If this function IS ASSIGNED, Users linked to the Group will be able access the Coin/Note Recycler
Menus to perform “Clear Jam/Error” functions.
Optional functions that can be performed from the Status menus (depending on Permission
Groups settings).
Audit Coins/Notes Configure recyclers Dispense to overflow
Empty Overflow Bin Note/Coin Exchange Prepare deposit
Perform Maintenance Transfer funds
Service Videos
Log In > Service Videos
Various corrective and replacement procedures can be viewed.
Set Date and Time
Log In > Maintenance Menu
The date and time can be set to the location (area/state/country).
To Next Page
Loading...
