3-59
3
Maintenance Menu
Log In > Maintenance Menu
The following functions can be performed from this menu:
X About
Licensing and copyright information are displayed.
X Accounting Period Names
The names of the files that are created when an “End Accounting Period” is performed
can be altered
X Copy Installation Files
X Copy Trace Files
Operational transaction log files will be saved to a flash drive.
X Device Statuses
A report containing operational status of each device incorporated on the TR Series
Recycler will be generated
X Door Solenoid and Sensors
A displayed diagram of doors, solenoids and sensors will be displayed
Sensors can be tested by blocking specific sensors and observing the results on the
displayed diagram.
Solenoids can be activated by selecting the desired door on the displayed diagram.
Refer to the Diagnostic Menu Chapter of the TR Series Service Manual
X Fingerprint Reader
A finger can be placed on the Fingerprint Reader.
A displayed image of the fingerprint indicates functionality.
X Hopper Reset
Each Hopper will be initialized and the reset status will be displayed
Hopper statistic odometers will be reset to “0”
X Hopper Statistics
Each Hopper is subjected to a request/acknowledgement routine.
The accumulated percentage of successful acknowledgements is displayed
This menu must be exited and re-selected each time an updated status is desired.
X iButton Diagnostics
An i-Key can be placed in the Reader socket.
If i-button encoding is displayed, the iButton Reader and i-Key are functioning
X NFC Reader Diagnostics
An NFC tag can be scanned - The Tag encoding will be displayed if the NFC Reader s
functioning.
CONTINUED ON NEXT PAGE
To Next Page
Loading...
