Tidel TR303 - Bill Validator ~ Rollers and Belts; Bill Validator ~ Sensors and Lenses; Front Transport - (B24 Door) - Belts and Sensors; Front Transport - (B24 Door) - Rollers

14
14-9
Note Recycler
#40 - Clean Rubber Rollers (8 TOTAL)
#39 - Clean Metal Rollers (6 TOTAL)
(A) Front Transport - (B24 Door) - Rollers
#47 - Exit Sensors (4 TOTAL)
#38 - Vacuum entire transport area
#46 - Bill Validator Lenses (2 TOTAL)
(B) Front Transport - (B24 Door) - Belts and Sensors
#43 - Clean Front Belts (Rotate by hand)
#42 - Clean Transport Sensors
#44 - Clean Rear Belts (Rotate right side gear)
#41 - Clean Upper Acrylic Lenes
(A) Bill Validator ~ Sensors and Lenses
#51 - Rubber Rollers (10 TOTAL)
#48 - Clean Red Rollers (8 TOTAL)
(B) Bill Validator ~ Rollers and Belts
#50 - Belts (6 TOTAL)
#45 - Wipe entire Feed Path Plastic frame parts (Front turning point and floor plates)
#49 - Rotate and vacuum brushes
#54 - Clean Rubber Rollers (6 TOTAL)
#53 - Rotate and clean Upper Belts
(C) Bill Validator Cavity
#55 - Clean metal rollers (6 TOTAL)
#52 - Vacuum, then wipe entire Bill Cavity area