7-18
7
Coin Hopper Service
Maintenance Reminder Intervals
The MAINTENANCE reminder is pre-set from the factory to appear after 500,000 coins have been
dispensed from any of the Coin Hoppers.
The reminder interval can be changed to appear between 1 and 999,999 coins.
Log In > Configuration Menu > Edit Configuration > Maintenance and Odometers
When the MAINTENANCE reminder is displayed, the Coin Hopper Base should be disassembled and
inspected for signs of wear on the feed/exit pathways and metal parts at the exit.
Hoppers should be replaced if excessive wear is visible.
Clearing the Maintenance reminder
1) Navigate to the Coin Recycler Menu.
Log In > Status (bottom tool bar) > Coin Recycler > Perform Maintenance
2) Select the desired Hopper and choose “REPLACE”.
3) Verify replacement was perform when prompted to reset the lifetime counter to “0”.
4) Repeat steps 2 & 3 to clear counters on replaced Hoppers.
Maintenance reminders will no longer appear after counter has been cleared.
Select the appropriate Hopper
1
0
0
0
2
3
4
00
00
00
00
0
Acceptor
Replace
Clean
Device Lifetime Clean Maintenance
0
5
00
0
6
00
0
7
00
0
8
00
0 0
0
Choose
REPLACE
To Next Page
Loading...
