1-17
1
Initial Start Up/Getting Started
Power Up Sequence
1) If a Coin Handler is paired with the Note Handler and is equipped with a UPS device:
a) Hold the On/Off button on the UPS until (2) beeps are heard (UPS should be ON).
2) Press the ON/OFF button at the top/left rear of the unit (facing unit) - The “white” indicator
should not be visible.
After power is applied:
After 30 ~ 60 second period, the Main Screen will be displayed.
The Main Screen may display errors, due to incomplete setup parameters (location specific).
Errors can be ignored, proceed with functionality checks.
Check Date and Time:
The Date and Time should be set to the site location prior to performing any operations.
Log In > Done > (1-2-3-4-5-6) > Maintenance Menu > Set Date and Time
Functional verification
Cash Handler Door Operations
Step 1: Ensure all Vault Doors are open/unlocked.
Step 2: Navigate to the Door Solenoid and Sensor Maintenance Menu:
Log In > Done > (1-2-3-4-5-6) > Maintenance Menu > Door Solenoids and Sensors
The displayed Sensor map should indicate all sensors are UNLOCKED ~ OPEN.
Step 1: With the Vault Door open, turn the Cash Handler Vault Door “T” Handle to the locked position.
Step 2: Turn the Combination Lock housing counter-clockwise (locked).
a) Ensure the housing cannot be rotated clockwise (unlocked).
b) Ensure the Vault Door “T” Handle cannot be turned to the unlocked position.
The displayed Sensor Map should indicate the LOCK Sensor is CLOSED
Step 3: From the displayed Sensor Map, activate the Solenoid by selecting the Cash Handler Vault.
a) The Solenoid should activate.
The displayed Sensor map should indicate the LOCK sensor is OPEN
Step 4: Block the Sensor at the top/center on the Vault Door.
The displayed Sensor map should indicate the DOOR Sensor is CLOSED
Step 5: Enter the default combination 1-2-3-4-5-6.
a) 2 beeps indicate correct entry.
b) Rotate the Combination Lock housing clockwise (unlocked)
c) Turn the Vault Door “T” Handle(s) to the UNLOCKED position.
To Next Page
Loading...