15-11
15
i-Key and Reader
No response when i-Key is placed in Reader
Log In > Maintenance Menu > i-button Diagnostic
1) Place a known working i-Key into the Reader socket (hold in place minimum 10 seconds).
2) If the last 4 numbers of the i-Key checksum and serial number are displayed, the i-Key Reader
and i-Key are functioning.
3) Ensure the i-Key is linked to an account.
Log In > User Management > Modify User > User Log In Setup > Login Data
If the i-Button selection is BLUE, no i-key is linked.
a) Select “i-button” to enroll/link a key to the selected User.
If the i-Button selection is subdued, an i-Key is enrolled.
a) Select re-scan and enroll/link a new key to the selected User.
4) Check the cable wiring connection at terminal U6 on the expansion dongle (located inside the
rear compartment on the Control Computer.
To Next Page
Loading...
