Cisco ASR 9000 Series Command Reference Guide

DescriptionField
Whether or not a far-end alarm code request is being
received. Possible values are as follows:
•
DS3 Eqpt. Failure (SA)
•
DS3 LOS/HBER
•
DS3 Out-of-Frame
•
DS3 AIS Received
•
DS3 IDLE Received
•
DS3 Eqpt. Failure (NSA)
•
Common Eqpt. Failure (NSA)
•
Multiple DS1 LOS/HBER
•
DS1 Eqpt. Failure
•
Single DS1 LOS/HBER
•
DS1 Eqpt. Failure (NSA)
•
No code is being received
FEAC code received
Framing type on the channelized controller. Values
are auto-detect, M23, and C-Bit.
Framing
Line coding format on the channelized controller.
Values are AMI and B8ZS.
Line Code
Clock source on the channelized controller. Values
are internal and line.
Clock Source
Values of the following alarm soaking intervals:
•
Alarm declarings: amount of time, in
milliseconds, after which an alarm is declared.
•
Alarm clearing: amount of time, in milliseconds,
after which an alarm is cleared.
Alarm Soaking Interval
Indicates the current state of the test. Can be one of
the following:
• running—BER test is still in progress.
• done—BER test is complete.
• not running—BER test is not running on the
controller.
BERT test result
Indicates the test pattern you selected for the test.Test Pattern
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1057
T3, E3, T1, E1 Controller Commands on the Cisco ASR 9000 Series Router
show controllers t3

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model