Cisco ASR 9000 Series Command Reference Guide

Table 65: show controllers wanphy Command Output Fields
DescriptionField
Identifies the WAN physical interface, in the format
rack/slot/module/port.
•
rack: Chassis number of the rack.
•
slot: Physical slot number of the line card.
•
module: Module number. A physical layer
interface module (PLIM) is always 0. Shared
port adapters (SPAs) are referenced by their
subslot number.
•
port: Physical port number of the interface.
Interface
Current configuration mode running on this controller.
Can be WAN mode or LAN mode.
Configuration Mode
Displays the following section alarms:
• LOF—Number of Loss of Framing (LOF) errors
on this connection section. LOF alarms are
critical because they indicate that the link
associated with this section is down.
• LOS—Number of loss of signal (LOS) errors
on this connection section. LOS alarms are
critical because they indicate that the link
associated with this section is down.
• BIP(B1)—Number of bit interleaved parity
(BIP) B1 errors on this section that exceeded
the specified threshold.
SECTION
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1107
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
show controllers wanphy

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model